About the button names in this explanation
<>
: Buttons on the main unit
[]: Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit
TP search
Use this function to find RDS stations broadcasting traffic programs
(TP stations).
Use
<
INPUT SELECTOR
>
to select “TUNER” or press
[TUNER].
Press PRESET.
• TP search begins automatically.
If no TP station is found with the above operation, all the reception
bands are searched.
The station name is displayed on the display after searching
stops.
Press
RDS
until “TP SEARCH” appears on the
display.
To continue searching, repeat step 3.
If no other TP station is found when all the frequencies have
been searched, “NO PROGRAMME” is displayed.
1
2
3
4
RT (Radio Text)
“RT” appears on the display when radio text data is received.
Use
<
INPUT SELECTOR
>
to select “TUNER” or press
[TUNER].
Press
<
RT
>
.
While receiving an RDS broadcast station, the text data
broadcast from the station is displayed.
To turn the display off, press
<
RT
>
again.
If no text data is being broadcast, “NO TEXT DATA” is displayed.
1
2
Switching RDS information display
Use the procedure described at “Auto tuning”,
“Manual tuning” or “Recalling preset stations” to
tune in a frequency with an RDS station.
Press STATUS to switch the RDS reception
information.
The display switches as shown below each time STATUS is
pressed.
q PS :
The programme service name and frequency of the station
tuned in is displayed.
The above is an example for when there is TP
data but no RT data.
1
2
w PTY :
The programme type of the tuned in broadcast is
displayed.
r CT :
The current time is displayed.
To Next Page
Loading...
