Denon DRA-500AE - Front Panel Display (FL DISPLAY); FL Display Grid Assignment

ENGLISH
ENGLISH
Operation Operation
12
Switching the brightness of the display
Press
<
DIMMER
>
.
The brightness of the display can be adjusted in three steps. The
display can also be turned off.
Checking the currently playing program source,
etc.
Press STATUS.
• The current program source and various settings are indicated on
the display.
This mode reproduces the sound with extremely high quality. The
audio signals do not pass through the tone circuits, etc., and the
display that could affect the audio signals are turned “OFF”.
Selecting the play mode (PURE DIRECT)
Press
<
PURE DIRECT
>
.
Use
<
SELECT
>
to set the level.
Can be adjusted within the range of –10 dB to +10 dB.
2
Press
<
TONE DEFEAT
>
to select “TONE DEFEAT ON”.
Adjusting the speaker volume
Press
<
CH VOL
>
to select the speaker.
The settable speaker switches each time this button is pressed.
Use
<
SELECT
>
to adjust the volume.
Can be adjusted within the range of –12 dB to +12 dB.
1
2
Setting the tone control
Press
<
TONE CONTROL
>
to select “BASS” or
“TREBLE”.
1
¢ Adjusting the tone
¢ When you do not want to adjust the tone
Press
<
LOUDNESS
>
to select “LOUDNESS ON”.
¢ When listening with the volume turned low
Listening to the radio
Hold
<
PRESET •
>
and press
<
ON/STANDBY
>
.
• The unit automatically begins searching for FM broadcast
stations.
When the first FM broadcast station is found, that station is
stored in the preset memory at channel A1.
Subsequent stations are automatically stored in order at preset
channels A1 to A8, B1 to B8, C1 to C8, D1 to D8, E1 to E8, F1 to
F8 and G1 to G8 for a maximum of 56 stations.
Channel A1 is tuned in after the auto preset memory operation is
completed.
Auto preset memory
This unit is equipped with a function for automatically searching for
FM broadcast stations and storing them in the preset memory.
• If an FM station cannot be preset automatically due to poor
reception, use the “Manual tuning” operation to tune in the station,
then preset it using the manual “Preset memory” operation.
•To interrupt this function, press
<
ON/STANDBY
>
.
¢ Default settings
Auto tuner presets
A1 ~ A8
87.5 / 89.1 / 98.1 / 108.0 / 90.1 / 90.1 / 90.1 /
90.1 MHz
B1 ~ B8
522 / 603 / 999 / 1404 / 1611 kHz, 90.1 /
90.1 / 90.1 MHz
C1 ~ C8 90.1 MHz
D1 ~ D8 90.1 MHz
E1 ~ E8 90.1 MHz
F1 ~ F8 90.1 MHz
G1 ~ G8 90.1 MHz
Press
<
ON/STANDBY
>
and set the DRA-500AE’s
power to the standby mode.
1
2