Denon DRA-F102 DAB - Time and Timer Functions; Setting Time and Using Timers

17
Operation Operation
Setting the current time
The DRA-F102 DAB’s clock displays the time in the 24-hour mode
Example: To set the current time to “19:30”
Using the timer function
Before setting the timer
¢ Types of timers
The DRA-F102 DAB has three timer functions.
qEveryday timer:
Use this to play or record at the set time every day.
wOnce timer:
Use this to play or record once only at the set time.
eSleep timer:
Use this to turn off the power after up to 90 minutes, set in
intervals of 10 minutes.
¢ Order of priority for the timers
• If the times set for the three timers overlap, the sleep timer has
priority.
• If the times set for the everyday and once timers overlap, the once
timer has priority.
¢ If there is a power cut
• The current time setting is canceled. Turn the power on and reset
the current time.
• The timer settings are cleared. Set the timer again.
• The tuner’s presettings may be cleared. If so, perform the
presetting procedure again.
Setting the everyday or once timer
• Be sure to set the current time first.
•To use the timer function to listen to AM or FM broadcasts, be sure
to preset the desired station first ( page 13).
Example: Listening to preset number “3” with the everyday timer
Press and hold MENU/SET.
• “TIME Adj” is displayed.
• The hour’s display flashes.
Use [8] or [9] to set the hours to “19”.
• “19” flashes.
Press [CLOCK].
2
Press MENU/SET simultaneously with the tone of a
time casting, etc.
• “TIME Adj” turns off.
• The current time is displayed.
6
3
1
Press MENU/SET.
• The minute’s display flashes.
4
Use [8] or [9] to set the minutes to “30”.
• “30” flashes.
5
• If MENU/SET is pressed before the time is set, the time setting mode
is set.
• If the current time has been set, it can be displayed by pressing
[CLOCK].
• In the standby mode, the current time can also be displayed by
pressing [MENU/SET].
NOTE:
• The time cannot be set when in the standby mode. Turn on the
power first.
Press MENU/SET once.
• “TIMER” flashes.
Use [8] or [9] to select “EVERYDAY”, then
press MENU/SET.
1
2
Perform steps 3 to 5 under “Setting the current
time” to set the timer start time.
5
Perform steps 3 to 5 under “Setting the current
time” to set the timer stop time.
6
Use [8] or [9] to select “TUNER”, then press
MENU/SET.
3
Use [8] or [9] to select preset number “3”,
then press MENU/SET.
•The presettings are stored in the memory.
4