18
Operation Operation
Use [8] or [9] to select “1_off / E_on”, then
press MENU/SET.
• The timer standby indicator “ ” lights. The time is now set.
For details, see “Operation of the everyday and once timers”.
7
Press <ON/STANDBY> or [POWER OFF].
• The power is set to the standby mode and the power indicator
lights orange.
When the timer start time is reached, the timer operates.
8
¢ If you make a mistake while setting the timer:
qPress BAND at any step from 3 ~ 6.
wUse MENU/SET to select the item you want to correct, them make
the correct setting.
eUse MENU/SET to proceed to step 7.
¢ To check the timer settings:
qPerform steps 1 and 2 on page 17.
wPress MENU/SET repeatedly.
¢ To change the timer settings:
Perform steps 1 ~ 8 at the left to change the settings as desired.
The timer settings change to the new settings.
To change a setting while still in the timer setting mode, press
BAND then perform steps 3 ~ 8 at on page 17 and above.
¢ To delete the timer settings:
qPerform steps 1 and 2 on page 17.
wPress and hold BAND while “EVERYDAY” or “ONCE” is displayed.
¢ To stop the timer setting:
Select “1_off/E_off” at step 2 under “Operation of the everyday
and once timers”.
NOTE:
• If the current time is not set, the timer standby indicator “ ”
will not light.
• When the timer is set, the timer standby indicator “ ” lights.
• Be sure to set the power to the standby mode when you want
the timer to operate.
After setting the timer at “Setting the everyday or once timer” (
page 17, 18), select the timer(s) you want to operate.
Press MENU/SET twice.
• The current settings are displayed.
Use [8] or [9] to select the timer(s) you want to
operate.
1
2
Neither the once nor the everyday
timer operates.
Both the once and the everyday timers
operate.
Only the everyday timer operates.
Only the once timer operates.
If only the everyday timer is set, the display switches as follows
when [8] or [9] is pressed.
If only the once timer is set, the display switches as follows
when [8] or [9] is pressed.
To Next Page
Loading...
