2
Getting Started Getting Started
Cautions on installation
About the remote control unit
The included remote control unit (RC-1034) can be used to operate
not only the DRA-F102 DAB but also other components in the F102
series ( page 4).
Wall
Note
Note:
For heat dispersal, do not install this unit in a confined space
such as a bookcase or similar enclosure.
q Remove the remote control
unit’s rear cover.
w Set two R03/AAA batteries in
the battery compartment in
the indicated direction.
e Put the rear cover back on.
Notes on batteries:
• Replace the batteries with new ones if the set does not operate
even when the remote control unit is operated nearby the unit.
(The attached batteries are only for verifying operation.)
• When inserting the batteries, be sure to do so in the proper
direction, following the “<” and “>” marks in the battery
compartment.
•To prevent damage or leakage of battery fluid:
• Do not use a new battery together with an old one.
•Do not use two different types of batteries.
•Do not short-circuit, disassemble, heat or dispose of batteries
in flames.
• Remove the batteries from the remote control unit when you do
not plan to use it for an extended period of time.
• If the battery fluid should leak, carefully wipe the fluid off the
inside of the battery compartment and insert new batteries.
• Remove the batteries from the remote if it will not be in use for
long periods.
30°
30°
Approx. 7 m
NOTE:
• It may be difficult to operate the remote control unit if the remote
sensor is exposed to direct sunlight or strong artificial light.
• Point the remote control unit at the remote sensor when operating
it.
• When using the remote control unit to operate other connected
F102 series components, point it at the remote control signal sensor
on the DRA-F102 DAB.
• The remote control unit can be used from a distance of up to about
7 meters, at a horizontal angle of up to 30° with respect to the
sensor.
Operating range of the remote control unit
Inserting the batteries
To Next Page
Loading...
