22
3. Cold start mode (initialization)
(1) Plug AC cord into power outlet while pressing "SOURCE" and "
8
/ -" button
same time on Main Unit.
Initialize.
I N I T I A L I Z E
Default
SOURCE DISC
TUNER BAND EK:DAB, other
FM
TUNER frequency Minimum reception frequency
TUNER PRESET 0
Set -/+ PRESET
SDB OFF
BASS 0
TREBLE 0
BLANCE CENTER
DIMMER 100%
VOLUME 8
Clock E3:AM12:00, Other:0:00
ALARM SOURCE DISC
ALARM ON E3:AM12:00, Other:0:00
ALARM OFF E3:AM12:00, Other:0:00
SPK OPTIMISE ON
iPod MODE REMOTE
AUTO STANDBY E2/EK:ON, E3:OFF
DAB Module (EK) Initialzed Module
Protection memory NO PROTECT
※
The following settings are not initialized.
• Laser ON TIME and Laser Current
•Powersupplyabnormalag
(2) After initialization, the unit will start in normal mode (Power On).
4. CD test mode
(1) Plug AC cord into power outlet while pressing "Power operation (
X
)" and "SOURCE" button same time on Main Unit.
"
1
3
"
0 0 C D T E S T M O D E
(
1
,
3
ashing
)
(2) Move the slide to the initially set position (10 mm towards the outside from the innermost position).
(3) Check by performing key input. Refer to 4.2
q
~
4.2
y
.
(4) Cancel the mode by turning the power back on.
※
Do not push the button without the explanation.
4.1 Disc loading
(1) Press the "
5
" button to open the tray.
(2) Set a disc on the tray, then press the "
5
" button again to close the tray.
(3) Move the slide to the initially set position (10 mm towards the outside from the innermost position) and stop in this
status.