8529-0637-2M Rev A DL Series Operation Manual
PRINT FORMAT
Paper Type: Press 【Paper Type】 for 4 seconds to switch between gap paper and plain
paper.
Format: There are 9 kinds of default print formats.
Label Size: 58mm x 40mm and 40mm x 30mm label, 58mm and 40mm width plain paper
are available in default print formats. When using different type of paper, please adjust the
corresponding Spec shown in the table below.
Print formats include label print and receipt print. If user needs custom print format, please
use PC software to change or contact with appointed after-service center.
Don’t print bills while selling: amend Spec003 and Spec008 to 0. If some specific deals
need to print bills, please press 【Reprint】.
To print a few copies of one bill, put the amount into Spec003 and Spec008.
To print two different kinds of bills: set the type of bill 1 in Spec000~Spec009, and bill 2 in
Spec010~Spec019. Strongly suggest users contact with appointed after-service center.
Set grey level of gap thermal paper in Spec022.
Set grey level of plain thermal paper in Spec023.
Set plain thermal paper in Spec 025, the position for cut-off paper suggest Spec025 not
less than 30.
You can set different kinds of print formats and barcode types for each PLU. You can check
the details in PLU parameters for print formats and barcode types. Set the value of these
parameters to 0 if you choose the system type.
The procedures to confirm print format: take bill 1 as an example. If two or more goods are
sold, print sum bill and use Spec005 as print format. If only one good is sold, print the item
bill. If sale PLU has been set for a specific print format (not 0), system would use the print
format. If no specific print format has been set to sale PLU (The setting number is 0.), the
print format would be Spec000.
To Next Page
Loading...
Need help?
General
