8529-0637-2M Rev A DL Series Operation Manual
INSTALLATION
Included in carton find:
Scale
Tray - 2 pcs: plastic tray & metal top
Display pole and screw pack (DL1030P only)
Operation Manual
DL Series Setup Utility CD
Four (4) overlays for shortcut PLU
Power Cord
Attachment of Tower Display
Remove cover tower bracket on bottom of base. Place the tower display in close proximity to
the base. Connect tower cable to circuit board in base. Gently slide the tower post into the
bracket. Fasten the tower to base with two bolts provided. Replace bracket cover.
Placement
Place the scale in an environment free of excessive dust and moisture and on a stable,
vibration-free level surface away from direct sunlight and any rapidly moving air source
(heating/cooling vents, fans, etc.). This will prevent sudden temperature changes and air
currents that may result in unstable weight readings.
WARNING! DO NOT place the scale on any unstable cart, stand or table. The scale
may fall causing injury to the operator, and damage the unit, or proper operation of
the scale may be inhibited.
Level Adjustment
Check to make certain the scale is level. The level indicator is located at the front of the scale.
If the scale is not level (the bubble will not be centered), adjust the mounting feet as required to
center the bubble and attain a level scale.
Power Connection
The scale uses an external AC power cord that is to be used in a standard 110/120 VAC
50/60Hz grounded wall outlet.
To Next Page
Loading...
Need help?
General
