36 Network configuration
devolo dLAN 550+ WiFi
Keep in mind that you also have to
enter the WiFi MAC address of your
own computer if you are connected
to the dLAN 550+ WiFi not via the
Ethernet port, but via WiFi. Otherwi-
se you will block your own access to
the device via WiFi by activating the
WiFi filter.
Save all modified settings before leaving this configu-
ration area again by pressing OK to confirm them.
4.3.6 WiFi Clone and WiFi Move
WiFi Clone
WiFi Clone lets you apply the WiFi access data of an
existing WiFi access point (such as your WiFi router) at
the touch of a button. Start the procedure with the
Start setup option and then press the WPS button of
the device with the WiFi access data (SSID and WiFi
password) to be applied.
WiFi Move
WiFi Move Technology is a function for synchronising
the WiFi settings of all devolo WiFi adapters connected
to your network.
The WiFi function and WiFi Move
Technology of the dLAN 550+ WiFi
are enabled by default.
You can enable synchronisation of the WiFi settings eit-
her by using the functions in this menu or by pressing
the respective encryption button with the home icon on
the corresponding adapters. To learn how to synchro-
nise the WiFi settings at the touch of a button, refer to
Chapters 2.6.1 Encryption button and 3.3
Connecting the dLAN 550+ WiFi.
WiFi Move Technology support enabled
Switch on WiFi Move Technology (if necessary) by clic-
king/tapping under WLAN configuration WiFi
Move. All WiFi adapters are now continuously
connected to each other and, from now on, share
changes to the WLAN configuration with each other
automatically.
In addition, you can see when the last synchronisation
took place and which devices are connected via
WiFi Move Technology.
4.3.7 WiFi Protected Setup (WPS)
WPS encryption off/on
You can enable or disable the WPS encryption of your
dLAN 550+ WiFi:
To Next Page
Loading...
Need help?
General
