Single port KVM over IP switch
The IP-KVM switch has a built-in super user that has all permissions to administrate your
IP-KVM switch:
Login name
super (factory default)
Password
pass (factory default)
Table 5-1. Standard user settings
Warning
The user “ super ” is not allowed to login via the serial interface of the IP-KVM switch.
Warning
Please make sure to change the super user password immediately after you have
installed and accessed your IP-KVM switch for the first time. Not changing the pass
phrase for the super user is a severe security risk and might result in unauthorized
access to the IP-KVM switch and to the host system including all possible
onsequences! c
Warning
Your web browser has to accept cookies, or else login is not possible.
Navigation
Having logged into the IP-KVM switch successfully, the main page of the IP-KVM switch
appears (see Figure 5-3 ). This page consists of three parts, each of them contains specific
information. The buttons on the upper side allow you to navigate within the front end (see
Table 5-2 for details). The lower left frame contains a navigation bar and allows you to switch
between the different sections of the IP-KVM switch. Within the right frame, task-specific
information is displayed that depends on the section you have chosen before.
Figure 5-3. Main page
To Next Page
Loading...
General