Single port KVM over IP switch
6.5.6 Date And Time
Figure 6-27. Date and Time
This link refers to a page, where the internal real-time clock of the IP-KVM switch can be set
up (see Figure 6-27). You have the possibility to adjust the clock manually, or to use a NTP
timeserver. Without a timeserver, your time setting will not be persistent, so you have to
adjust it again, after IP-KVM switch loses power for more than a few minutes. To avoid this,
you can use a NTP timeserver, which sets up the internal clock automatically to the current
UTC time. Because NTP server time is always UTC, there is a setting that allows you to set
up a static offset to get your local time.
Warning
There is currently no way to adjust the daylight saving time automatically. So you
have to set up the UTC offset twice a year properly to the local rules of your country.
To Next Page
Loading...