Single port KVM over IP switch
Video Settings through the remote console
Figure 5-11. Video Settings Panel
Brightness
Controls the brightness of the picture
Contrast
Controls the contrast of the picture
Clock
Defines the horizontal frequency for a video line and depends on the video
mode. Different video card types may require different values here. The default
settings in conjuction with the auto adjustment procedure should be adequate
for all common configurations. If the picture quality is still bad after auto
adjustment you may try to change this setting together with the sampling phase
to achieve a better quality.
Phase
Defines the phase for video sampling, used to control the display quality
together with the setting for sampling clock.
Horizontal Position
Use the left and right buttons to move the picture in horizontal direction while
this option is selected.
Vertical Position
Use the left and right buttons to move the picture in vertical direction while this
option is selected.
Reset this Mode
Reset mode specific settings to the factory-made defaults.
To Next Page
Loading...
General