Dexter Laundry T-650

To Next Page

To Previous Page

8514-300-001 REV PR

7. “Date”- Similar to “Time”, if a problem occurs and the RTC date is not accurate, it can

be reset to the current date using this option.

a. The day of the month in “DATE” can be set by using the “Up” or “Down” buttons

to change the number that is flashing. Once the desired day of the month is

chosen, press the “Enter” button to move to the month of the year. Once the

desired month of the year is chosen, press the “Enter” button to move to the

year. Once the day, month and year are all chosen, the “Enter” button must be

held down for 3 seconds to confirm that RTC is meant to be reset to the

complete entry.

“Out of Service” – The control can be put into an Out-of-Service mode via manual

programming. When the mode is “ON”, the control will scroll “OUT OF SERVICE” on the

display. The machine will not react to any vend input and will not operate when in this

mode. The factory default is “OFF”.

“Drive Table”- The control knows what model of washer it is installed in based on

various inputs including information it receives from the Variable Frequency Drive (VFD).

However, because multiple VFD’s can be used on the same model, depending on when

it was manufactured, the “DRIVE TABLE” option is available. “DRIVE ERROR 1” will

display on the control when the Drive Table setting does not match the appropriate VFD

in the washer.

Choose “Drive 3” for C4 models (ex. WC0600XA-12EC4X-)

Choose “Drive 2” for C1, C2, or C3 models (ex. WC0600XA-12EC2X-)

Choose “Drive 1” for WCAD models (ex. WCAD40KCS)

Contact your local Dexter distributor for more information.

10. “Display Error Codes” – If the user programs the Display Error Codes to “OFF”, the

control will not display the non-critical errors (non-cycle ending errors) if they occur

during the cycle. This includes “Slow Fill Error” and “Slow Drain Error” codes. The

factory default is “ON”.

11. “Add Bleach” – If the user programs the “Add Bleach” setting to “OFF”, the control will

not display the “Add Bleach” prompt during the cycle. The factory default is “ON”.

To reset all values in the Settings options to factory default, press “Enter” when the “DEFAULT”

prompt is shown. Press “Enter” again when the “RESET” prompt is shown to confirm the action.

Dexter Laundry T-650 - Page 82