B. Based on your internet browser the le needs to be saved as “AllUser.xml”. Depending
on your Internet browser you may need to retrieve the le from
your “Downloads” folder, which is located under “Computer”..
Note: The newly created programing le may have changed from the proper “AllUser.xml.
Machine programming will not occur using a dierent le name than “AllUser.xml”. Any
extra extension names will require the le to be renamed back to “AllUser.xml” for the
machine to recognize the le.
7) To save the Programming File to a USB Drive:
A. Move or Copy the “AllUser.xml” le from your computer onto a USB drive.
B. Based on your computer and internet browser, this le may be found in your “Down
loads” folder, which is located under the “COmputer” area.
Note: The “AllUser.xml” le size is small, nearly any capacity USB drive will do.
8) Program Your Machines Using the USB Drive
CAUTION!!! Be sure that any loose keys or other items that are connected to the USB de-
vice are removed from the USB stick to prevent any possible metal contact
with the control board.
A. Insert the USB drive containing the “AllUser.xml” le into the Dexter machines you
wish to program. The control will scroll “…………” while identifying the program on
the USB. Once identied, the display will scroll “INSTALL USER FILE FROM USB”. At
this prompt press the green start button on the front panel.
34
Part # 8533-081-001 1/18
To Next Page
Loading...
Need help?
General
