Dialab GmbH
Operator's Manual DIAcheck series Rev-4 Page 24
2.8 TECAM SMART
Requirements:
License: TECAM SMART fingerprint and activation code.
Cable: USB, type A to B, max 3m
Interface: USB
Setting: no handshake or protocol. Barcode must be finished with carriage
return.
Installation:
a) Disconnect the device from PC.
b) Run setup.exe.
c) Confirm when asked to install DIAcheck series driver.
d) Connect device with PC.
e) Start TECAM
Further information available in chapter “7” or online help file of TECAM.
To Next Page
Loading...
