MODEL BMG-535 GRINDER
SECTION 6 OPERATION
42
Grinding & Polishing
OPERATING MANUAL
APRIL 2009
The process described in Section 5.2 “Initial Operation” shall be followed during
the normal start up of the BMG-535 for daily operation.
Verify that the electric cable and dust hose are clear from vehicle traffic, such as
forklifts and other equipment.
To switch off the machine, push the red “STOP” button on the operator control
panel (7). See Figure 5.1 in Section 5.2 for additional details.
If there are any doubts as to how to start up the machine, read
Sections 5.1 and 5.2 of this operating manual.
6.2 SWITCHING OFF THE MACHINE
To Next Page
Loading...
