MODEL BMG-535 GRINDER
SECTION 6 OPERATION
43
Grinding & Polishing
OPERATING MANUAL
APRIL 2009
The machine has to be in its Safety off position before starting repair work. See
Section 2.6.
The local safety regulations are valid in all cases regarding the operation of the
machine and will always supersede any instructions provided in this manual.
6.3 TROUBLE SHUTDOWN
In case of emergency or operating trouble, such as vibrations or
loud noises, switch the machine off immediately by pushing the
Emergency Stop (E-Stop) button on the operator control panel
(8)
.
6.4 SAFETY SHUTDOWN
Before performing inspection or maintenance work make sure
that all moving machine parts are stopped. Observe the Safety
off position, Section 2.6.
6.5 RESTARTING AFTE
A FAULT
The results of all electrical repair work must be verified using the
appropriate measurement techniques per the regulations stated
in the European VBG4 and VDE 0701 standards or per the
applicable U.S. guidelines, as appropriate. See also Section 5.2
Initial operation.
To Next Page
Loading...
