Operating Guidelines
Placement
• The unit should be placed indoors on a at and level surface. The unit can be mounted vertically on a
wall or other surface with additional user supplied hardware (such as screws, mounting tape, or industrial
strength Velcro).
Using Wired Sensors
• When using the wired sensors, care should be taken so that the cable is managed in such a way that it
not accidentally unplugged from the unit. If the external sensor is removed from the unit, the unit will not
be able to monitor the environmental conditions.
Wireless Reception
• The Ethernet Gateway has one antenna. This antenna allows for wireless connection to your SmartSense
wireless sensors.
Powering the Unit
• We recommend that the unit be connected to an uninterruptible power supply (UPS) or battery backup.
If power the gateway is lost, readings from hardwired sensors stored in the local memory will be lost and
the gateway will not be able to record temperatures and send alarms. We recommend disconnecting
power for 10 seconds or more before powering up the gateway again. Passive PoE can be used as an
alternative means of power. It is recommended to use the Passive PoE injectors purchased directly from
us to ensure proper performance. The gateway is not compatible with Active PoE.
For more information about SmartSense visit www.smartsense.co or call 1-866-806-2653
© 1996
-
2018 Digi International Inc. All rights reserved. All other trademarks are the property of their respective owners.
P10
A1/818
To Next Page
Loading...
Need help?
General
