Digi XBee - Part 3: Establish an 802.11 Bgn Network Connection; Starting the X-CTU Software

©2011DigiInternational,Inc.. 9
Part 3: Establish an 802.11 bgn Network
Connection
Twotypesofnetworkconnectionareavailable.Thefirstisad‐hocwhereatwomodulenetworkis
establishedwithouttheaidofanaccesspointorrouter.Thismodeisnotdiscussedinthisguide.Further
informationonad‐hocnetworksisavailableintheUser'sManual.Thesecondtype
ofnetworkiscreated
usinganaccesspointorrouter.Thebasicsofthistypeofconnectionwillbecoveredinthissection.
Starting the X-CTU Software
1.ConnecttheXBeeUSBDevelopmentBoardUSBcabletothecomputer.
2.GotothefilewhereyousavedtheX‐CTUsoftware.
3.Double‐clickonX‐CTU.exetostarttheprogram.