3.8
Description
Q Returns code
Enable or disable the return codes from Tintoretto to the Computer.
Q0 Messages transmission enabled
Q1 Messages transmission disabled
Q3 Reserved
Q4 Reserved
Q5 Reserved
Store: S14 (bit 0,2,4) S52 (bit 0) Default= Q0
S S Registers
Show and change the contect of "r" register
Sr=xxx Store the number xxx, in hexadecimal digit, in the “r” register (from 0 to 255).
Sr? Display the value of "r" register (from 0 to 255)
Store: n/a Default= n/a
V Numeric and Verbose Messages
Select the type of the return code from Tintoretto to the Computer. Can be selected the numeric
mode to manage Tintoretto by a PC and the verbose mode to manage Tintoretto by an operator.
Using the numeric mode the return codes are followed by the <CR> char.
Using the verbose mode the return code are preceded and followed by the <CR> and <LF>
character.
V0 Return codes displayed in numeric mode
V1 Return codes displayed in verbose mode
Store: S14 (bit 3) Default= V1
X Select Return Codes
X Select the return code types
X0 Enable return codes from 0 to 4
X1 Enable all return codes
X2 For compatibility only
X3 For compatibility only
X4 For compatibility only
Store: S24 (bit 3) S22 (bit 4, 5, 6) Default=X1
Following the table including all the result messages in numeric and verbose mode:
To Next Page
Loading...
Need help?
General
