Digicom Tintoretto User Manual

Description
3.9
NUMERIC VERBOSE
0OK
1 CONNECT
2RING
3 NO CARRIER
4 ERROR
6 NO DIALTONE
7 BUSY
5 CONNECT 1200
10 CONNECT 2400
11 CONNECT 4800
12 CONNECT 9600
14 CONNECT 19200
28 CONNECT 38400
32 CONNECT 48000
18 CONNECT 57600
19 CONNECT 64000
20 CONNECT 115200
46 CARRIER 1200
47 CARRIER 2400
48 CARRIER 4800
49 CARRIER 7200
50 CARRIER 9600
54 CARRIER 19200
56 CARRIER 38400
NUMERIC VERBOSE
39 CARRIER 48000
59 CARRIER 64000
60 CARRIER 128000
83 PROTOCOL: V120
84 PROTOCOL: V110
85 PROTOCOL:V120 COMPRESSION
86 PROTOCOL:PPP
87 PROTOCOL:MLPP
46 84 CONNECT 1200/V110
47 84 CONNECT 2400/V110
48 84 CONNECT 4800/V110
49 84 CONNECT 7200/V110
50 84 CONNECT 9600/V110
51 84 CONNECT 12000/V110
52 84 CONNECT 14400/V110
54 84 CONNECT 19200/V110
56 84 CONNECT 38400/V110
39 84 CONNECT 48000/V110
58 84 CONNECT 64000/V110
59 83 CONNECT 64000/V120
59 85 CONNECT 64000/V120COMP
59 86 CONNECT 64000/PPP
60 87 CONNECT 128000/MLPPP
W Protocol result code
Enable protocol result code (see ATX command)
W0 Partial result code. When the connection is established, Tintoretto send the connection message
CONNECT followed the interface speed.
W1 Complete result code. When the connection is established, Tintoretto send these connection
messages:
CARRIER xxxx
PROTOCOL xxxx
CONNECT xxxx
W2 Complete result code. When the connection is established, Tintoretto send these connection
messages:
CONNECT “Line Speed”/”Protocol”
like
CONNECT 64000/V120
This command is connected with the ATV (Verbose Mode) command.
Store: S24 (bit 5, 6) Default= W1

Digicom Tintoretto Specifications

General

Brand	Digicom
Model	Tintoretto
Category	Modem
Language	English