DR5000 DIGICENTRAL
P 6
www.digikeijs.com ® R-Bus, B-Bus are trademarks which are registered in the name of Modelleisenbahn GmbH. XpressNet and RS-Bus is a trademark registered in the name of Lenz Elektronik GmbH
2.1 General product informaon
The DR5000 is a universal DCC controller suitable for virtually all variees of connecons that are currently available. The controller can deal with LocoNet and
XpressNet equipment and through Wi-Fi and also with mobile handhelds. Through a LAN, Wi-Fi connecon or a USB connecon it can be connected to a PC
whereby you can choose the LocoNet or ExpressNet protocol. So any supporng soware, such as iTrain, Koploper, Windigipet, Train controller and RocRail can
communicate with this controller. Peripheral equipment such as the Roco Mulmaus, the Lenz LH01, the Daisy (wired or wireless) and other LocoNet or Xpress-
Net compable equipment can be connected and used simultaneously.
The maximum power of the DR5000 controller is 3 amps. If you need more power please use a booster with an H bridge connector, such as the DR5033. Older
boosters with a so-called Common ground connector (e.g. Märklin®) are not suitable and lead to short circuing or permanent damage.
The maximum power of the DR5000 controller is 3 amps. If you need more power please use a booster with an H bridge output, such as the DR5033. Older
boosters with a so-called Common ground output (e.g. Märklin®) are not suitable and lead to short circuing or permanent damage.
2.2 Technical specicaons
Protocol : DCC
Speed levels : 14/28/128
Decoders : 117 simultaneously
Decoder addresses : 9999, short addresses adjustable to max. 126 steps
Solenoids : 2048 DCC solenoids
Power : 3 amps
Output : H-Bridge
Connecons : LocoNet B® (a maximum of 128 modules with 16 inputs / 600mA / RailCom®)
LocoNet T® ((a maximum of 128 modules with 16 inputs / 600mA / RailCom®)
XpressNet® (maximaal 30 MulMause / 600mA)
B-Bus® (a maximum of 4 boosters)
R-Bus® (a maximum of 10 modules with 16 inputs)
S88-N (a maximum of 16 modules with 16 inputs)
RS-Bus® (a maximum of 32 modules with 16 inputs)
Programming Track (simultaneous driving and programming possible)
Power connecon (a minimum of 14 volts, a maximum of 20 volts)
USB (LocoNet® and XpressNet-USB 3.6)
LAN (100 Mbit) (Lenz-LAN 3.6 and LocoNet LBServer)
Wi-Fi (Lenz-LAN 3.6 and LocoNet-LBServer)
Infrared receiver (compable with Uhlenbrock® and Piko®)
Soware iTrain, RocRail, Koploper, Traincontroller, DecoderPro
Win-Digipet and other compable with LocoNet® or XpressNet®
To Next Page
Loading...
Need help?
General