NOTIFY
Enable and select for the sensor notification to create a buzzer sound and/or a pop-up warning
when triggered.
When “Camera pop-up” is enabled, in a multi-screen mode, the system will switch to single-
channel mode and automatically when the alarm is triggered.
Camera Alarm
Set up the NVR to start recording when motion is detected. The system can also trigger an alarm signal
via the selected sensor-out channel. Motion detection must be enabled and configured within the
associated camera for the NVR to detect motion.
ON/OFF
Turn on or turn off the camera alarm. When turned ON, the NVR will trigger an event alarm when
motion is detected.
RELAY
Select related output. The NVR will output a signal through the selected relay output port (RS-485).
Relay contacts can bear up to 24V 1A other devices. If it is connected to a power source
of more than 24V 1A, the system may have a problem with it.
DWELL
Set sensor operation time between 1 and 15 seconds. The camera alarm will remain active until the
assigned dwell time has passed.
PRE-ALARM
Set a recording period in seconds just before motion is detected. Input up to 5 seconds. The pre-
alarm recording mode is always “continuous” at the recording speed that the user sets in the
“Record” menu.
MOTION AREA
Set the camera’s motion area and sensitivity. The area can be selected by clicking on a specific block
or dragging the mouse’s cursor across the screen to select multiple blocks. Areas where motion
detection is activated will appear with a green border. Unselected areas will be shown with a grey
border.
Type” while “Wet Contact Type” may cause damage to the system.
To Next Page
Loading...
