1. Click [SET] in the ‘MOTION AREA’ section to set the area.
2. Select the motion detection area and click [SAVE] and then [EXIT] to save the changes.
Clicking on SELECT ALL will enable motion detection in the entire camera’s FoV.
Motion detection area and sensitivity should be set, properly, in consideration of the actual
motion that happened on the site.
COPY SETTING
To apply the settings to all cameras connected to the NVR, click on the Copy Settings button:
1. Select the channel to get the setting from
2. Select the property(s) to copy.
3. Select the target channel(s) to apply the setting.
4. Click [OK] to apply the setting to all the other selected channel(s).
EVENT MONITOR
Show the event number for each camera. It shows check count numbers, motion detection and
sensor detection.
NOTIFY
Enable and select for the sensor notification to create a buzzer sound and/or a pop-up warning
when triggered.
When “Camera pop-up” is enabled, in a multi-screen mode, the system will switch to single-
channel mode and automatically when the alarm is triggered.
To Next Page
Loading...
