Recording Schedule
Set a recording schedule for each individual camera. Select a camera from the channel numbers at the
top to set a schedule for an individual camera or select “All” to apply the same recording schedule to
all camera channels. Recording can be set by each hour from 00 through 23 a day, for all days of the
week. You can also set up a special recording mode for holidays.
NO COLOR (Off)
No recording. Even though user-set recording frames in the “CAMERA” setup menu, the system will
not record anything if the user sets “OFF” in the schedule table.
YELLOW (Continuous Recording)
Record all the time as set in the “CAMERA” settings.
GREEN (Motion-Detection Recording)
The system records only when motion is detected.
If “ALARM > CAMERA ALARM” is disabled, then the system will record when motion is detected but
the motion alarm will not be activated.
ORANGE (Sensor-Activated Recording)
The system records only when a sensor is triggered as set in the “ALARM > SENSOR” menu.
If “ALARM > SENSOR” is disabled, then the system will record when a sensor is triggered but the
sensor alarm will not be activated.
SKY BLUE (Continuous + Motion Detection Recording)
The system records continuously as set by the “RECORD > CAMERA” menu.
When motion is detected according to the settings in “ALARM > EVENT ALARM”, the NVR will
switch recording mode to motion configuration. If “ALARM > EVENT ALARM” is disabled, then the
system will record when motion is detected but the motion alarm will not be activated.
BROWN (Continuous + Sensor-Activated Recording)
The system records continuously as set by the “RECORD > CAMERA” menu.
When a sensor is triggered according to the settings in “ALARM > SENSOR”, the NVR will switch
recording mode to motion configuration. If “ALARM > SENSOR” is disabled, then the system will
record when a sensor is triggered but the sensor alarm will not be activated.
PINK (Motion Detection + Sensor-Activated Recording)
The system records only when motion is detected AND when a sensor is triggered at the same time.
If both “ALARM > SENSOR” and “ALARM > EVENT ALARM” is disabled, then the system will record
To Next Page
Loading...
