Notification
REMOTE NOTIFY
The system can send an alarm message to the IP address of a Remote Software P/C.
Select REMOTE NOTIFY to use this function and set IP address & events.
• IP ADDRESS: Input the IP address of the PC hosting the remote viewing software that will
be receiving the event notifications.
• PORT: (Default is 8003) Input the port number that is used to communicate with the
remote software PC.
• EVENT: Select which events to send notifications for. If “ALL” is selected, all events will
trigger a remote notification.
EMAIL NOTIFY
The system can send a notification to an email address. Select EMAIL NOTIFY to use this function
and set email addresses and events.
• EMAIL: Enter the email address that will receive the events notifications.
• EVENT: Select which events will trigger notifications. If “ALL” is selected, all the events will
trigger a notification.
• SNAPSHOT NOTIFY SETUP: Select camera channels to include live snapshot images of
selected channels to the email address. Set the dwell time between camera image captures.
• VIDEO CLIP ATTACHMENT: Select to include a short video clip with the email notification
when either a sensor or motion detection (CAMERA ALARM) has triggered the notification.
The event type must also be selected.
To Next Page
Loading...
