NOTIFICATION SETTINGS
• OUTGOING MAIL SMTP SERVER: Input the SMTP server that is being used to send the
notifications. Check with your email service provider for SMTP server information.
• YOUR EMAIL ACCOUNT USER NAME: Input the username or email address from which the
notifications will be sent.
• YOUR EMAIL ADDRESS: Input the email address of the account that will be used to send the
email notifications.
• OPTION: Set the authentication method supported by the server. There are ‘None/Use Plain
Auth/No Auth’ options.
• CONNECTION: Set the connection type supported by the email server. There are ‘Unsecure
Connection/Use SSL Authentication/Use TLS Authentication’ options. Check with your email
service provider for more information about authentication requirements.
• PORT: Input the port number that will be used for email sending. Check with your email
service provider for more information on the port that is used for SMTP.
• PASSWORD: Input the email password to the account that is being used to send the
notification emails.
• INTERVAL: For email notification, select how frequently the system will be allowed to send
out an update email.
• EMAIL TEST: Click to check if the settings were entered correctly. The NVR will send a test
email and inform you of the result. Depending on the email service, the SMTP server may not
send an email confirmation if the email was received.
Configuration priority is always on the “RECORD > SCHEDULE” menu.
The system will not email alarm messages upon motion alarm or sensor even though the
checkbox of the above event is checked. To receive motion and sensor email notifications,
set the “SCHEDULE > RECORD”, “EVENT > MOTION ALARM” and “EVENT > SENSOR”
accordingly.
To Next Page
Loading...
