1.Power up unit while pressing the UP footswitch until TOE dn is displayed.
2.Rock the Expression pedal forward (toe down position).
3.Press a footswitch,until TOE up is displayed.
4.Rock the Expression pedal forward (toe up position).
5.Press a footswitch again to complete calibration.
Note: If error is displayed, an error has occurred in the calibration and all
steps must be repeated. This calibration procedure does not erase user
presets.
Factory Reset
This function resets the BP200 to its original factory settings. This procedure erases all
custom user presets,and recalibrates the Expression Pedal. To complete a factory reset,
do the following:
Attention: ALL user defined presets will be lost if this function is performed!
1.Disconnect the power supply from the BP200.
2.Press and hold the SELECT button while connecting the power supply.
3.When rst ? displays, release the button and press the STORE button. rEset dis-
plays and the BP200 is reset.
Once a factory reset has been completed,it is required to calibrate the Expression Pedal.
Follow steps 2-5 of the calibration procedure outlined in the previous section.
16
To Next Page
Loading...
Need help?
General
