Bypass Mode
The BP200 can be bypassed so only a clean,unprocessed bass signal is heard. To bypass
the BP200,do the following:
1.Press both footswitches simultaneously. Bypass appears in the display.
2.Press either of the footswitches again to return to Performance mode with all edits in
tact.
Note: the SELECT, RHYTHM,and STORE buttons, and the AMP TYPE,GAIN,
and MASTER LEVEL knobs are disabled in Bypass mode.
Tuner Mode
The tuner in the BP200 lets you quickly tune or check the tuning of your bass. To access
the Tuner do the following:
1.Press and hold both foot switches until TUNER appears in the display.
2.Begin playing and the note appears in the display. The Matrix LED’s indicate whether
the note is sharp (red LED’s lit above the green CABINET-GATE LED ) or flat (red
LED’s lit below the green CABINET-GATE LED). When the note is in tune, only the
green CABINET-GATE LED is lit.
3.Press the SELECT button to select the tuning reference (A=440,A=Ab,A=G,A=Gb)
4.Rotate the AMP TYPE,GAIN, and MASTER LEVEL knobs to change the tuning
reference in semitone steps. This setting is maintained until changed by the user or a
factory reset is performed.
12
To Next Page
Loading...
Need help?
General
