Effects
The Effects row has several effects to choose from:Off, Chorus,Flanger, Phaser, Vibrato,
Octavider,SynthTalk™,Envelope Filter,Pitch,Detune, and Whammy™. When the Effects
row is selected, the following settings apply:
Type - Selects the type of effect used in the EFFECTS module.
Amount - Controls different aspects of effects depending on the type selected.
Level - Controls Level,Depth,or Mix depending on type selected.
Note: Only one of the effects in this row can be used at a time.
Chorus
A chorus adds a short delay to your signal. The delayed signal is modulated in and out
of tune and mixed back with the original signal to create a thicker sound.
Amount - Rotate the GAIN knob to simultaneously adjust the effect’s speed and
depth (1-99).
Effect Level - Rotate the MASTER LEVEL knob to adjust chorus the level (1-99).
Flanger
A flanger uses the same principle as a chorus but uses a shorter delay time and adds
regeneration (repeats) to the modulating delay. This results in an exaggerated up and
down sweeping motion of the effect.
Amount - Rotate the GAIN knob to simultaneously adjust the effect’s speed and
depth (1-99).
Effect Level - Rotate the MASTER LEVEL knob to adjust the flanger level (1-99).
21
To Next Page
Loading...
Need help?
General
