Connecting an instrument cable to the Input applies power to the BP50. Disconnecting
your instrument from the Input of the BP50 disconnects the battery power. Turn your
amplifier(s) on and adjust the volume(s) to a normal playing level. To prolong the battery
life, disconnect your instrument from the BP50’s Input when it is not in use .
AC Power
The BP50 can also be powered with the optional PS200R power supply. Connect the plug
of the PS200R power supply to the power jack on the rear panel of the BP50. Connect the
other end of the PS200R power supply to an AC outlet. Turn your amplifier(s) on and
adjust the volume(s)to a normal playing level.
About the BP50
The Presets
Presets are numbered locations of programmed sounds. Presets are recalled with the
Footswitches. The BP50 comes with 40 User Presets (Presets 1-40) and 40 Factory Presets
(Presets 41-80). The User Presets are locations where you can store presets. The Factory
Presets may not be saved over. From the factory, the 40 User Presets are exact duplicates
of the 40 Factory Presets.
Play Mode
When you first apply power to the BP50, it powers up in Play mode. The far left LED lights,
indicating you’re in Play mode. In Play mode, use the Up and Down Footswitches to access
the presets.
8
To Next Page
Loading...
Need help?
General
