Digitus DN-16032 - Zoom In Display Functionality; Motion Detection Setup

`
DN-16032 User’s Guide
P
P
a
a
n
n
/
/
T
T
i
i
l
l
t
t
I
I
P
P
S
S
u
u
r
r
v
v
e
e
i
i
l
l
l
l
a
a
n
n
c
c
e
e
C
C
a
a
m
m
e
e
r
r
a
a
DN-16032 USER’S GUIDE PAGE 35/61 Rev. PV1.0
4.3 ZOOM IN DISPLAY
Using your mouse, click and drag out a box to select the portion of video that you wish to
view as shown by the grey box in the image below. The image will zoom in according to
the dimensions entered and will show an image similar to this below (
)：
4.4 MOTION DETECTION SETUP
Setting up the Motion Detection (MD) values, including the first area (red border) and
second area (green border).
Please check to see whether the Event Trigger has been enabled. If so, you can set up
Motion Detection as described below:
- Reset MD range: Select motion detect 1or2, and hold down on the left mouse button
(this will appear as the upper left corner of the MD range). Then, drag out the desired
range, and release when finished.
( 、 )
- Cancel MD: Same as above, but just left click once and release. This will cancel the
MD (Motion Detection).