Digitus DN-16032 - Mail Server Configuration; FTP Server Configuration

`
DN-16032 User’s Guide
P
P
a
a
n
n
/
/
T
T
i
i
l
l
t
t
I
I
P
P
S
S
u
u
r
r
v
v
e
e
i
i
l
l
l
l
a
a
n
n
c
c
e
e
C
C
a
a
m
m
e
e
r
r
a
a
DN-16032 USER’S GUIDE PAGE 42/61 Rev. PV1.0
5.5.1 Mail Server
This refers to settings pertaining to sending image files via a mail server. You must also
make sure that the Mail Image settings from
are enabled to e-mail a file to
the designated address upon event trigger. This system supports SMTP (Simple Mail
Transfer Protocol) servers.
How to use mail server settings:
Step 1: Enter the IP address or http web address of the mail server in “IP/Host”.
Step 2: Enter the e-mail address of the sender in “Mail From”.
Step 3: Enter the e-mail address of the recipient in “Receipt to”.
Step 4: Enter the registered account ID of the mail server in “Account ID”
Step 5: Enter the correct mail server password in “Password”
Step 6: Enter whether or not your mail server requires authorization in “Authorization”
Step 7: Click on Submit when you are finished.
5.5.2 FTP Server
This menu allows you to enter the FTP (File Transfer Protocol) Server settings. You must
also make sure that the FTP Image settings from
are enabled to send a file
to the designated FTP server via FTP upon event trigger. This system supports Port