`
DN-16032 User’s Guide
P
P
a
a
n
n
/
/
T
T
i
i
l
l
t
t
I
I
P
P
S
S
u
u
r
r
v
v
e
e
i
i
l
l
l
l
a
a
n
n
c
c
e
e
C
C
a
a
m
m
e
e
r
r
a
a
DN-16032 USER’S GUIDE PAGE 9/61 Rev. PV1.0
B. Check if the IP addresses for PC network and CAM_EZ Search are on the
same network section:
Usually, static IP address will be used to access into Internet, so the IP
address will vary. When you want to change IP address, please write
down the original IP address on your computer first. Then you have to
modify the IP address of your computer for testing if the IP-CAM can be
operated normally or not. After finishing the test, IP address for your
computer should be recovered to original settings.
In general, the IP address for your computer in LAN will be set with
“Auto Obtain IP address”. To test if the IP-CAM is normal or not, the IP
address of your computer must be changed temporarily. After finishing
the test, it can be recovered to original settings.
C. Next, choose Control Panel->Network Connections->choose the activated
area
Network Connections---> right click your mouse --->select Properties(P)--->
Select Internet Protocol (TCP/IP)---> Select Properties(R) , then you can
check the current IP address status for the computer. The way to modify IP
address is:
D. Open and execute CAM_EZ Search (as shown in Figure 2). The system will
scan the IP-CAM that you just installed automatically. Then, you will find
255DN-16032 in the column of Camera Lists. Click 255DN-16032 with left
mouse button. You can see the default settings for IP-CAM.
IP Address(I):192.168.9.5
Subnet Mask (U):255.255.255.0
Default Gateway(D):192.168.9.254
To Next Page
Loading...
Need help?
General
