Dimplex BLF5051 - Hardwire Installation: Component Removal; Removing Panels and Electrical Box

9
sure on the partially reective
glass, tilt the replace upright
and slightly forward to allow
the partially reective glass to
fall out of the inside framing.
CAUTION: Partially reective
glass is not tempered. Do not
bump or drop the partially reec-
tive glass to avoid breakage and
personal injury.
• Remove partially reective
glass from replace.
2. Locate the power cord and
remove the 3 screws that at-
tach the metal bracket to the
unit - one on the back of the
unit and two on the bottom.
(Figure 4)
3. From the front, remove the 2
Philips screws that fasten the
front panel tabs, tilt the panel
Fireplace Installation
Figure 6
Wires to
controls
Wire connectors
Junction
Box screw
Figure 5
Electrical box
Screw
Figure 3
Front Panel
Front Panel tabs (2)
Acrylic Tray screws (4)
White neutral
wires
Black live
wires
Metal Tray
Screws (4)
Figure 4
Junction Box screws (3)