Dimplex CDFI1000P - Maintenance; Filling the Water Tank

15
WARNING: Disconnect power
before attempting any main-
tenance or cleaning to reduce
the risk of re, electric shock
or damage to persons.
Filling the water tank
When the water tank is empty,
the ame effect shuts off and you
will hear 2 audible beeps, follow
these steps.
CAUTION: Allow at least ve
minutes for components to cool
before disassembling the unit to
rell.
1. Gently remove the top tray and
place it carefully on the ground.
2. Turn the On/Off switch to the
off position (0) (Figure 4A)
3. Remove the rell container by
lifting upwards and outwards.
4. Rell the container with tap
water.
!
NOTE: Normal tap water can
be used in the Optimyst
®
as long
as the tap water is not considered
to be hard water. In the event
your tap water is hard, you may
use softened water or distilled
water with ⅛ tsp. of salt (0.5 mL)
added to the water reservoir. (The
use of additional salt should only
be when you notice that the unit is
not producing mist as expected.)
5. Screw the cap back on, do not
overtighten.
6. Return the rell container to the
sump, with the tank cap facing
down and the at side of the
tank facing outward.
7. Turn the On/Off switch to the
off position (I). (Figure 4A)
8. Gently place the top tray back
into position.
If you do not intend on using
the unit for longer than 2 weeks,
empty and drain the unit of water,
and dry all of the water containing
components.
Transducer Replacement
After prolonged usage the abil-
ity for the unit to produce mist
may become reduced. When this
occurs the replacement of the
transducer may be required. This
unit comes with 2 additional trans-
ducers, located behind the right
module, which can installed when
this occurs.
!
NOTE: There is a small tab
that holds the transducer in place,
that needs to be released before
it can be removed.
Maintenance