15
Figure 7
A
C D E F
Display
Figure 8
A
D
B
C
E
G
J
F
G
H
I
Operation
→ Activated by pressing the
button on the remote.
C. Heat ON/OFF
Turns the heater On and Off.
→ Activated by pressing the
button on the remote or the
unit.
• Indicated by the
icon and
the setpoint temperature will
ash on the display, then the
intake temperature will be dis-
played before turning off.
!
NOTE: After the heater is
switched off, there is a 2 minute
fan delay, where the fan will con-
tinue running before turning off.
!
NOTE: The unit can be oper-
ated in Heat Only Mode. When
the unit is only running with the
heater, the
icon will continu-
ously be displayed on the Display.
!
NOTE: The heater may emit
a slight, harmless odor when rst
used. This odor is a normal condi-
tion caused by initial heating of
internal heater parts and will not
occur again.
D
Temperature Down
Decreases the temperature set-
ting.
→ Adjusted by repeatedly press-
ing the corresponding button
on the remote.*
• Indicated by setpoint tempera-
ture on the Display decreasing
and the speed of the fan de-
creasing to reduce the amount
of heat being projected into the
I
J
To Next Page
Loading...
