16 www.dimplex.com
• Indicated by the Display and a
reduced fan speed.
G.
Heat Boost
Turns the Heater Boost On and
Off. Runs the unit at the full rated
wattage.
→ Activated and adjusted by
repeatedly pressing the corre-
sponding button on the remote.
• Indicated by the heater run-
ning at full heat, for a user set
amount of time, to quickly heat
up a cold room/space. The
Heat Boost can be set for a
maximum of 20 minutes, in 5
minute increments.
Disable Heat
If desired, depending on the
season, the heater on the unit can
be disabled. The function of the
remaining controls will continue
to function as outlined in this
manual.
Pressing the and buttons
on the unit at the same time and
holding for 2 seconds will disable
and enable the heater.
!
NOTE: When the heater has
been disabled and any of the heat
related functions are used, the
Display will indicate "---".
room.**
E. Temperature Up
Increases the temperature set-
ting.
→ Adjusted by repeatedly press-
ing the corresponding button
on the remote.*
• Indicated by the setpoint on
the Display increasing and the
speed of the fan increasing to
increase the amount of heat
being projected into the room.
* The rst time the button is
pressed the current tempera-
ture set point will be displayed
for 2 seconds.
** The temperature can be ad-
justed from 5 °C to 32 °C (41
°F to 90 °F).
!
NOTE: Holding the and the
buttons down for two sec-
onds, on the unit, will change the
temperature scale from °C to °F,
or vice versa.
F.
Eco Operation
Runs the heater in a reduced
wattage range when activated.
→ Adjusted by pressing the corre-
sponding button on the remote
when the heater is on.
Operation
To Next Page
Loading...
Need help?
General
