17
H. Sleep Timer
The Sleep Timer can be set to
automatically shut off the replace
after a preset time (from 30 min-
utes to 8 hours).
→ To set the timer press the timer
button on the remote, repeat-
edly, until the desired time is
displayed.
• The Display will display the
different times as it is adjusted.
Once the timer has begun,
pressing the button will dis-
play the time remaining before
the unit turns Off.
!
NOTE: The Sleep Timer can
be cancelled at any time by
pressing the button repeat-
edly until the sleep timer displays
nothing.
Resetting the Temperature
Cutoff Switch
Should the heater overheat, an
automatic cut out will turn the
whole unit off and it will not come
back on without being reset. If the
button on the unit is pressed,
Er2 will be displayed on the unit.
It can be reset by turning the unit
off at the main disconnect panel
and waiting 5 minutes before turn-
F. Color Themes
Different presets of lighting color
combinations are available in the
unit.
→ Changed by repeatedly press-
ing the corresponding button
on the remote or the unit.
• Cycles through the different
preset light settings of the unit,
this includes different combi-
nations of colors of the ame
base and media lighting.
!
NOTE: Two of the themes in
the cycle are a prism where the
unit cycles through a variety of
colors. Pressing the stops
the cycling and holds the unit on
the preferred color, indicated by
a solid circle. When the unit is
on prism, and is cycling through
the colors, a rotating circle will be
displayed.
G.
Brightness
Changes the Brightness of the
lights in the unit.
→ Adjusted by repeatedly press-
ing the corresponding button
on the remote or the unit.
• Indicated by the second digit
on the Display changing to
show: "H" (high), and "L" (low).
Operation
To Next Page
Loading...
Need help?
General
