DINGLI BT22ERT - Page 13

Work Area Safety
9
The workers must follow the instructions put in
place by the employer, the workplace and the
national safety standards in force concerning
use of the personal protective equipment for
protection from falling from a height.
Always observe the use the direction arrows
with color codes on the platform controls and
on the chassis and the organs for side-shift
and steering operations.
Do not lower the
boom if the area
underneath is not
clear of persons or
obstructions.
Reduce the transfer
speed according to
the conditions of the
ground, the traffic,
the slopes, presence
of workers or other
factors which can
cause collisions.
Danger of personal injuries
Always use the machine in a well-ventilated
area to prevent the risk of poisoning by carbon
monoxide.
Do not use the machine if there is an oil or air
leak. Hydraulic or air leaks can cause injury to
the skin and burns.
Contact with the components present in any of
the compartments can cause serious personal
injury. Access to the machine compartments
must only be allowed for workers qualified for
maintenance. Access these compartments
only during pre-operative checks. All the
compartments must remain closed and locked
during the working of the machine.
Danger of explosion and fire
Do not start up the motor if there is an odour or
trace of LPG, petrol, diesel or other explosive
substances.
Do not recharge the machine if the electrical
motor is switched on.
Recharge the machine solely in a
well-ventilated area far away from sparks,
flames and lighted cigarettes.
Do not use the machine in hazardous ambient
or in the presence of gas or flammable or
explosive materials or in areas with explosive
atmosphere.
Dangers due to faulty
machine
Do not use damaged or faulty machines.
Proceed with detailed pre-operative checking
of the machine and test all the functions before
each work shift. Mark and put damaged or
faulty machines immediately out of service.
Make sure the maintenance checks have been
carried out as specified in this Manual and in
the DINGLI Maintenance Manual concerned.
Make sure all the stickers are present and
legible.
Make sure the Operator Manual, Manuals on
safety and responsibilities are intact, legible
and placed safe inside the container
concerned on the machine.
Hazards linked to the work
area
Do not use the machine in environmental
temperatures below -20°C or above 40°C. To
operate at other environmental temperatures,
contact the manufacturer.