Work Area Safety
Electrocution Hazards
The machine has no electrical isolation and
does not provide protection from contact or
proximity to electricity lines.
Observe the local
and national
regulatory
standards in force
concerning the
distance required
from electricity
lines. At least the
safety distance
indicated in the
Table below must
be respected.
Move away from the
machine in case of
contact with live
electricity lines.
Workers on the
ground or on the
platform must not
touch or operate the
machine until the
electric power supply
has been
disconnected.
Do not use the machine in case of thunder
storms or lightning. Do not use the machine as
earth for carrying out welding operations.
Danger of tilting over
The workers, equipment and materials must
not exceed the maximum capacity of the
platform or of the platform extension element.
Maximum platform capacity
Maximum
number of
occupants
If accessories are used, read, understand and
follow the indications on the stickers,
instructions and Manuals supplied with the
accessories.
Do not raise or extend
the boom unless the
machine is placed on
a stable level surface.
Never exceed the
maximum permitted
inclination of the truck;
the maximum
permitted inclination of
the truck is indicated
in the technical
specifications and on
the ID plate on-board
the machine.
Do not use the inclination alarm as a level
indicator. The inclination alarm sounds in the
platform only when the machine is on a steep
slope.
If the inclination alarm sounds when the boom
is lowered, do not extend, rotate or raise the
boom with respect to the horizontal position.
Move the machine to a stable level surface
before lifting the platform.
If the inclination alarm sounds while the
platform is lifted, use it with utmost care. The
indicator lights up if the machine is not level
To Next Page
Loading...
