Work Area Safety
Danger due to movement on
slopes
Do not move the machine on a slope that
exceeds the maximum limits established for
ascent, descent and lateral movement of the
machine. The slope limit only refers to
machines in the retracted position.
Note: The slope limit depends on the
conditions of the ground and presupposes an
adequate traction. Consult the section
regarding the machine transfer on a slope in
the operating instructions chapter.
Danger of falling
The workers in the
platform must wear a
safety belt or harness
in compliance with
the national
regulations in force.
Fix the safety cord to
the fittings present on
the platform and
indicated by the
graph alongside.
Do not sit, stand or
climb on the railings
of the platform.
Always maintain a
stable position on the
platform foot board.
Do not climb down
from the platform if it
is raised.
Keep the platform foot board free of detritus.
Lower the safety bar or close the entrance
gate before using the platform.
Do not enter or leave the platform if the
machine is not in a retracted position and the
platform is not at ground level.
Danger of collision
Take care in situations of pure visibility and
blind spots while driving or during the man
oeuvre.
Take into consideration the position of the
boom or the drift during the rotation of the
slewing ring gear.
Check the work area
to make sure there
are no obstacles at a
height or other
potential hazards.
Take extreme care
while gripping the
platform railing to
prevent danger of
crushing.
To Next Page
Loading...
