DINGLI BT22ERT - Workplace Inspection

Workplace Inspection
31
√ Before using the machine, it is necessary
to understand and apply the fundamental
principles regarding the working of the
machine in the safety conditions contained
in this Operator's Manual.
1 Avoid hazard situations.
2 Always carry out the pre-operative
inspection.
3 Check the work area.
Read and understand the work area
before proceeding with the next section.
4 Always carry out functional test before
using the machine.
5 Use the machine only for the purposes
for which it is designed: operating
instructions.
Fundamental elements of
control of the work area
The control of the work area makes it possible
for the operator to decide whether the work
area is compatible with the working of the
machine in safety conditions. The checking
must be done by the operator before
transporting the machine to the work place.
It is the operator's responsibility to remember
the hazards concerning the work area and,
consequently, be ready to avoid these during
the movement, preparation and the working of
the machine.
Inspection of the workplace
Identify and avoid the following hazard
situations:
 cliffs or ditches

dips, obstructions along the floor or
detritus
 sloping surfaces
 support surfaces not suitable to withstand
the load stresses cause by the machine

obstacles present above the machine and
high voltage electricity lines
 wind exceeding 12.5 m/s and
unfavourable atmospheric conditions (rain,
snow, etc.)

ambient temperature less than -20°C or
more than 40°C
 presence of explosive atmosphere

poor or insufficient lighting

insufficient ventilation
 hazardous environments
 presence of unauthorized workers
 other potential hazard conditions