Recharge
It is necessary to recharge the battery when
the battery runs low or after completing
long-time operation.
There are two power sockets on the end of Li
battery tank, near the front axle. No 1 for rapid
charge, and No 2 for trickle charge. The power
sockets are as follows.
Note
：
Put the right electric plug into the
corresponding socket when the charge
mode is chosen. Otherwise, there will be
some damage for Li battery or
spontaneous combustion.
Trickle charge mode
Push one end of the charging plug into the
socket and push the other end in the external
electric supply socket.
Rapid charge mode
The rapid charge mode can be chosen if there
is charging pile bought from DingLi.
Note
：
The charging pile must be bought
from DingLi when the rapid charge mode is
chosen. Otherwise, there will be some
damage for Li battery or spontaneous
combustion.
Put the electric plug on the charging pile into
the socket for rapid charge, as follows:
And then call our department of server for the
operation instruction of the charging pile.
It is completed when the one hundred percent
of battery capacity appears on the display.
Note: it is better to choose an appropriate
charging line, under fifteen meters.
Please contact with our department of server.
To Next Page
Loading...
