E-1 Lubricate oil in the axle box-
Change
1 Place suitable sized containers under the
axle. Remove the three drainage caps 2.
Wait for the oil to drain out completely. To
speed up the operation, remove filler cap
1.
2 Refit caps 2 and tighten adequately.
Remove level cap 1.
3 Pour fresh oil of the correct type through
hole 1. Fill in stages and check the flow of
oil through level hole 1.
4 When the correct level is reached, refit
level cap 1.
Note: change the oil every 100-250 hours
firstly.
E-2 Wheel reduction gears oil -
Change
1 Place a suitable sized container under the
reduction gear. Turn the reduction gear
cap in position 1.
2 Remove the cap and wait for the oil to
drain out completely.
3 Turn the reduction gear cap in position 2.
Fill oil through the hole to the correct level.
4 Refit the cap. Repeat this operation for
each wheel.
Note: change the oil every 100-250 hours
firstly.
To Next Page
Loading...
