E-5 Overload Sensor -
calibration
How much the load weighted by the overload
sensor is in the platform will be indicated on
the panel on the ground control console. If the
load in the platform does not exceed rated
load, the vehicle is safe during work.
Otherwise, it is dangerous and the alarm will
be activated. So, the sensor must be
calibrated when the data showed on the panel
is incorrect.
Calibration
The weighting system must be calibrated
termly. The interval is 1000 hours for running
or every year. Besides, stop to calibrate the
overload sensor at once the data showed on
the panel is incorrect.
E-6 Differentials oil - Change
1 Place suitable sized containers under the
axle. Remove the oil fill plug 1, Wait until
the internal pressure is completely
released. Remove the oil drain plug and
wait for the oil to drain out completely.
2 Refit the cap 2 and tighten adequately.
3 Pour fresh oil of the correct type through
hole 1. Fill in stages and check the flow of
oil through level hole 1.
4 When the correct level is reached, refit
level cap 1.
Note: change the oil every 100-250 hours
firstly.
To Next Page
Loading...
