Dinolift 205RXT - Check the Emergency Descent, Emergency Stop and Sound Signal; Signs, Labels and Machine Plates; Instruction Manuals

18
DINO RXT
3.1.7. Check the emergency descent, emergency stop and sound signal
Test the correct operation of emergency stop, emergency descent system and the sound
signal from the lower controls and platform controls.
• lifttheboomupapproximately1-2metersanddrivethetelescopeout1-2meters.While
driving the movement, push down the emergency stop button. The movement should
stop.
• Drive the telescope in and lower the boom by using emergency descent
• lift up the emergency stop button
• test the sound signal
3.1.8. Signs, labels and machine plates
Make sure, thet all the plates, adhesive tapes and instructional labels on control stations are
intact, clean and legible.
If the labels have started to come off or tear apart or if the symbols or texts are illegible the
labels must be replaced.
Product numbers of labels are marked on the labels or they can be found in the spare part
lists.
All ANSI safety labels are listed in this manual.
3.1.9. Instruction manuals
Check that the instruction manuals accompanying the platform are correctly stored on the
platform and that they are legible.