Dinolift 205RXT - Instructions for Service and Inspections Every 6 Months; Check and Lubricate the Turning Device and Gear Ring; Lubricate the Telescope Cylinder Bearings; Lubricate The Flyer-Chain

22
DINO RXT
4.2. INSTRUCTIONS FOR SERVICE AND INSPECTIONS EVERY 6 MONTHS
These service measures must be done between annual service at every 6 months or 500
hours,whichevercomesrst.
Always do all daily inspections and monthly service measures in addition to the service tasks
described here.
4.2.1. Check and lubricate the turning device and gear ring
Perform overall visual inspection of the turning device and its weldings. Check especially the
attachment of joints and angular gear.
Lubricatetheturningdevicebearingsandgearring(4nipples).
Number 13 in lubrication plan.
DANGER
WARNING
CAUTION
NOTICE
Excess grease pressure may press out the turning bearing seal.
4.2.2. Lubricate the telescope cylinder bearings
Add new lubricant until the grease coming out of the joint is clean. Wipe off excess grease if
necessary.
Lubricant: Esso Beacon EP2 or equivalent.
Number 12 in lubrication plan.
4.2.3. Lubricate the yer-chain
LubricatethevisiblepartsoftheFlyer-chainsfortheboomtwiceayear.UseMasterchain
lubricant1-4014orequivalent.
4.2.4. Check the tyres and tyre pressures
Check the wheel bolts and rims.
Check the condition of the tyres and check tyre pressures.
Thepressureshouldbe300kPa(3bar)
4.2.5. Check the drive functions
Check the proper operation of the drive motors . Check that the steering works properly with
every steering mode.
Check the condition of the brakes and test that they work properly.