© 2003 Directed Electronics, Inc. Vista, CA 29
10 ACCESSORY STATE DURING WAIT-TO-START: This will allow the programming of the accessory wire during the
wait-to-start period of a diesel motor. When ON the accessory comes on when the wait-to-start output is acti-
vated and stays on, dropping out during crank and returning once the car has started. When OFF the accessory
will activate as a normal accessory.
11 2
nd
STATUS OUTPUT: This wire will turn on when remote starting is initialized in status mode. In defogger
mode it will activate 10 seconds after the car has started. The output can be programmed to a latched or a pulsed
output. When programmed to the latched output the status will only stay active for 10 minutes.
shutdown diagnostics
The unit has the ability to report the cause of the last shutdown of the remote start system. To enter diagnostic
mode:
1. Turn the ignition off.
2. Press and HOLD the Program switch.
3. Turn the ignition on and then off.
4. Release the Program switch.
5. Press and release the Program switch.
To Next Page
Loading...
