30 © 2003 Directed Electronics, Inc. Vista, CA
The LED will now report the last system shutdown by flashing for one minute in the following grouped patterns:
The LED will stop flashing when the ignition is turned on.
timer mode
This unit can be programmed to start and run the engine every three hours. The engine will run for the pro-
grammed run time and then shut down. After three hours, the unit will restart the engine. A maximum of six
cycles can occur.
IMPORTANT! Timer Mode should be used only in open areas. Never start and run the vehicle in an
enclosed space such as a garage or carport.
To enter Timer Mode:
1. Turn the ignition on.
2. Press and HOLD the activation input to the remote start.
3. Turn the ignition off while holding the activation input.
4. Release the activation input.
The parking lights (if connected) will flash four times and the engine will start. The system is in Timer Mode. The
engine may be allowed to run for its programmed run time, or the activation input can be used to shut down the
engine. Either way, the remote start system will restart the engine again in three hours. Timer Mode is exited
automatically after the sixth run cycle.
LED SHUTDOWN
FLASHES MODE
One System timed out
Two Over-rev shutdown
Three Low or no RPM
Four Transmitter Shutdown (or optional push-button)
Six (-) Shutdown
Seven (-) Neutral safety shutdown (H2/6 BLACK/WHITE)
Eight Wait-to-start timed out
To Next Page
Loading...
Need help?
General
